Specifications
TANK
2000 litre main tank with separate 120 litre flush tank. 4 litre hand-wash tank.
Impact resistant polyethylene tank with UV-stabilised finish.
Calibrated sight gauge on front and side, flip-open filling lid with large basket strainer, separate chemical Chem induction probe and 1¼” drain valve. Deep sump design for total draining and liquid pick-up in sloping ground.
FAN OPTIONS
»» Kiwiliner - 820mm DSV Front-entry fan - stainless steel shroud and rear plate, downstream adjustable straightening vanes, NEW design glass-reinforced nylon polymer blades with adjustable pitch, 14 roll-over bodies per side, 2-speed oil-bath gearbox, centrifugal fan clutch. Optional second spray ring
PUMPS
ARBHS170 pump with brass heads and manifolds, oil-backed diaphragm type with chemical resistant diaphragms. 0-50 bar rated, 161 L/min (open-flow, zero pressure).
Optional ARBHS200 pump with brass heads and manifolds, oil-backed diaphragm type with chemical resistant diaphragms. 0-50 bar rated, 194 L/min (open-flow, zero pressure).
DRIVE (SH5AG)
Heavy duty PTO driveshaft comes with safety covers and quick release pins. Optional CV shaft.
CONTROLS
Remote mounted two-tap brass block controller with individual left/right shut-off, pressure adjustment and glycerine-filled gauge. Pressure and bypass regulator mounted on the pump.
Optional electric and auto rate controllers – see options
AGITATION
Supa-flo agitator and full bypass while filling with PRV in bypass mode
FILTRATION
Lid strainer, large suction filter. Optional pressure filters.
NOZZLES
Brass swing-over nozzle bodies, automatic shut-off type when in the half-turn position.
All units supplied with one set of ceramic hollow cone ALBUZ nozzles. Discs and cores optional.
CHASSIS
»» Hot-dipped galvanised, full-length with adjustable drawbar and single step, 6-stud wheel hubs, bumper bar comes with leaf guard. Side bumpers fitted standard for headland protection. Fixed axle standard; optional adjustable height and width axle.
»» Jockey wheel supplied on all models
WHEELS
»» Kiwiliner 2000 – steel rims, 27 x 9.5-15”
POWER REQUIRED - FAN ONLY
920mm DSV fan – minimum 37kW (50 hp) at PTO
20mm FE fan – minimum 34kW (45 hp) at PTO
Options
DRIVE AND HITCH
HT-CV Wide angle constant velocity PTO shaft
HT-SDB1 Self-steer draw bar. Must have HT-CV option
SPRAY CONTROL
HT-IS4021 Electric left/right 2-section on/off solenoids, electric pressure adjustment with integrated pressure filter and master switch with dump solenoid
HT-HV2400-SOL2 Croplands auto-rate controller, 2-section using on/off solenoid valves
HT-HV2400-SOL4 Croplands auto-rate controller, 4-section using on/off solenoid valves. Note - HT-SPLIT4SEC or HT-C218 must be added for this option
HT-SOL4SECT Upgrade to 4 x section solenoid valves for use with 4-section spray ring (HT-SPLIT4SEC)
HT-BRAVO180/S Bravo 180S auto rate controller with 2-section suing on/off solenoid valves
FAN ACCESSORIES
B146.504.1070 In-line brass pressure filters (pair) {add extra set for twin rings on Kiwiliner}
HT-KLC KLC-72 nozzle with manual dual feed taps
HT-SPLIT4SEC 4 section spray ring, comes with swing-over nozzle bodies and one set of Albuz ATR's supplied. For auto-rate or electric four section control, please check before ordering as extra cost is involved
WHEEL OPTIONS
HT-HP202T 13.0 x 55 - 16" flotation tyres in lieu of standard tyre
